Installing Memory Modules - HP B132L+ Owner's Manual

3 Close the ejector tabs on each side of the memory connector to lessen the force
4 Line up the memory module with the guides making sure that the notched end of
Figure 47

Installing Memory Modules

5 Press firmly and evenly on the memory module to ensure that it is fully seated.
6 Install the memory retainer.
7 To verify that this installation was successful, follow the steps in Appendix D,
required to seat the memory module, as shown in Figure 47.
the memory module is toward the white ejector tab (front of the main tray), as
shown in Figure 47.
White Ejector Tab
"The Boot Console Interface," on displaying memory information. If you have
only replaced a faulty memory module, you must issue the pdt clear command in
the service menu of the Boot Console Interface. Answer yes (y) to the prompt
"Continue? (Y/N) >."
Changing Your Workstation's Hardware Configuration
Installing Additional memory
143