Installing A Cd-Rom Or Dds Tape - HP B132L+ Owner's Manual

Changing Your Workstation's Hardware Configuration
Installing Storage Devices
2 From the front of the storage tray, line up the slides on the CD-ROM or DDS tape
Figure 29
3 Push the CD-ROM or tape drive in about half way.
4 Connect the single-ended SCSI data cable and the power cable to the drive.
5 Push the drive in all of the way until you hear and feel the slides snap into place
6 Connect the CD-ROM audio cable to the CD-ROM drive.
7 Feed the CD-ROM audio cable out of the storage tray opening.
8 Proceed to the section entitled Replacing the Storage Tray Cover on page 132.
122
drive with the slots in the storage tray, and slide it into place, as shown in Figure
29.

Installing a CD-ROM or DDS Tape