Fwd Scsi Ids - HP B132L+ Owner's Manual

NOTICE: The C1700A Magneto-Optical Autochanger uses three SCSI IDs, and
accounts for three of the seven devices allowed on the SCSI bus
8 Check to see which SCSI device IDs are not used. You may use ID numbers 0
CAUTION: Do not use SCSI device ID 7 for any device. It is reserved for the built-in SCSI bus
controller.

FWD SCSI IDs

Before assigning a SCSI device ID to your drive, you need to check your
SCSI device IDs. To check which SCSI device IDs are available and assign
an ID to your device, follow these instructions which use Table 26.
1 Write in the type of internal drives currently connected to your system under the
2 Add your new drive to the table.
3 Check to see what SCSI device IDs are not used. You may use ID numbers 0
through 6 if they are not already in use. If the default ID on your drive does not
conflict with any existing drive IDs, use that ID. If your default address conflicts
with an existing drive ID, you need to assign a new SCSI device ID to your drive.
Refer to the drive's installation documentation for information on changing the
device ID.
heading "Fast, Wide SCSI Device Drives" and each drive's SCSI device ID un-
der the heading "Device ID."
through 6 and 8 through 15 if they are not already in use. If the default ID on your
drive does not conflict with any existing drive IDs, use that ID. If your default
address conflicts with an existing drive ID, assign a new fast, wide differential
SCSI device ID to your drive. Refer to the drive's installation documentation for
information on changing the device ID.
SCSI Connections
Assigning SCSI Device IDs
187