Connecting The Floppy Drive Data Cable - HP B132L+ Owner's Manual

Changing Your Workstation's Hardware Configuration
Installing Storage Devices
9 Connect the cable to the floppy drive.
Figure 37
10 Proceed to the section entitled Replacing the Storage Tray Cover on page 132.
130
When connecting the floppy data cable, use the following procedure, as shown
in Figure 37:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector until the blue line is even with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.

Connecting the Floppy Drive Data Cable