Replacing Mass Storage Devices; Procedure; Selecting Device Address; Default Scsi Addressing - HP Model 745 - VME Workstation Handbook

Replacing Mass Storage Devices

NOTE:

Procedure

1 Remove the system top cover using the procedure earlier in this chapter.
2 If replacing a device go to Selecting Device Address.
3 If the only action is to remove a device go to Mass Storage Device Removal.

Selecting Device Address

Procedure
1 Unpack the device.
2 Set only jumpers or switches that are required to change the device SCSI address, any
others should remain as shipped.
The default SCSI addresses for devices is shown in Table 5-4. You should check the
address as set on the failing drive and set the address on the new drive to the same
value.
Table 5-4
All Installation procedures are the reverse of removal in this
section.

Default SCSI Addressing

1st Hard Disk Drive
2nd Hard Disk Drive
3rd Hard Disk Drive
DDS Drive
CD-ROM Drive
Floppy Drive
Replacing Mass Storage Devices
ID 6
ID 5
ID 4
ID 3
ID 2
ID 0
5-29