Connecting The Storage Tray Cables - HP B132L+ Owner's Manual

Changing Your Workstation's Hardware Configuration
Installing Storage Devices
5 Reconnect the floppy, SE SCSI, power, CD-ROM audio, and FW SCSI cables as
Storage Tray
Power
Figure 41
134
shown in Figure 41. Reconnect rear-panel SCSI connector terminators, if neces-
sary.
When connecting the floppy cable to the system board, use the following proce-
dure:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector until the blue line is even with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
FWSCSI
SESCSI
CD Audio
Floppy Connector

Connecting the Storage Tray Cables