Preparing To Install Your Storage Device; Configuring Your Storage Device; Determining Your Storage Devices Position; Default Scsi Ids - HP B132L+ Owner's Manual

Preparing to Install Your Storage Device

This section describes information that you need to consider and procedures
that you need to perform before installing any storage device.
Configuring your Storage Device
Table 15 lists the recommended SCSI IDs for internal storage devices. If an
existing device already uses one of the suggested IDs, select an alternate ID.
Table 15

Default SCSI IDs

Fast, Wide SCSI and Ultra Wide SCSI
1st Hard Disk Drive
2nd Hard Disk Drive
Note: The Fast, Wide SCSI and Ultra Wide controller
is set to SCSI ID 7.
Single-Ended SCSI
CD-ROM Drive
DDS Drive
1st Hard Disk Drive
2nd Hard Disk Drive
Notes: The floppy drive is NOT a SCSI device.
NOTICE: The floppy disk drive is not a SCSI device.
Set the jumpers and SCSI IDs according to the installation instructions that
came with your device. Narrow Single-Ended SCSI can use addresses in the
range 0 through 7, with 7 reserved for the controller. Fast, Wide Differential
and Ultra, Wide Single-Ended SCSI can use addresses in the range 0 through
15, with 7 reserved for the controller.

Determining Your Storage Devices Position

Each storage device is restricted as to where in the storage tray it may be
installed. Before installing a storage device, use Figure 23 and Table 16 to
determine which disk tray position is correct for your device.
Each SCSI controller uses SCSI ID 7.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
ID 6
ID 5
ID 2
ID 3
ID 6
ID 5
115