Connectors And Terminators; Scsi Configuration Constraints; Narrow-Se Scsi Bus Configuration Constraints; Narrow-Se Scsi Bus Configuration Constraints - HP B132L+ Owner's Manual

Connectors and Terminators

Any NSE SCSI device connecting to the system must use a 50-pin high-den-
sity thumb screw connector on the end connecting to the systems external
connector.
Any FWD SCSI device connecting to the system must use a 68-pin high-
density thumb screw connector on both ends.
Any ultra, wide-SE SCSI device connecting to the system must use a 68-pin
high-density thumb screw connector on both ends
If no external devices are connected to any SCSI connector on the
NOTICE:
back panel, a SCSI terminator must be installed. The last device
connected to the SCSI bus must be terminated with a SCSI
terminator. All of the devices listed ship without terminators. If you
do not already have a SCSI terminator, you must order a C2905A,
68-pin terminator for the FWD SCSI bus, a C2904A, 50-pin high
density terminator for the NSE SCSI bus or a C2972A, 68-pin
terminator for the ultra, wide-SE SCSI bus from Hewlett-Packard.
SCSI Configuration Constraints
You are limited to the number of same-type SCSI devices per system. Before
adding another SCSI device, determine if the system can support the addi-
tional device.
This workstation offers the following types of SCSI bus, each with its own
configuration constraints:
•
•
•

Narrow-SE SCSI Bus Configuration Constraints

For the narrow-SE SCSI bus, HP-UX supports only one of each type of
removable disk drive and two of the same type tape devices per system.
Table 19 shows configuration constraints for each NSE SCSI device type. If
the system has an internal CD-ROM drive, tape drive or hard disks con-
nected to the SE SCSI bus, you must count them as SE SCSI devices.
NSE SCSI bus
Optional FWD SCSI bus
Ultra, wide-SE SCSI
SCSI Connections
SCSI Restrictions
.
177