Led Warning Conditions; Dds-Dc (Later Model) And Dds-2 Tape Drive Led Display Codes - HP B132L+ Owner's Manual

Using Your Digital Data Storage (DDS) Tape Drive
DDS Tape Drive and Data Cassette Descriptions
Tape
Any
Any
Figure 14

LED Warning Conditions

The following sections describe actions to take if the LEDs indicate a warn-
ing condition.
High Humidity
too high. The drive does not perform any operations until the humidity
drops.
Self-Test (Failure)
was diagnosed during the self tests. Note the pattern of the pulses and con-
tact your local service representative.
Media Wear (Caution)
number of errors they have to correct when reading and writing to a tape to
determine tape wear and tape head cleanliness. If excessive tape wear or
dirty tape heads are suspected, the drive warns you by displaying the Media
Wear (Caution) signal on the LED indicators.
52
Clean/ Meaning
Attention
Activity — load or unload
Activity — read or write
Cartridge loaded
Cleaning needed
Fault

DDS-DC (Later Model) and DDS-2 Tape Drive LED Display Codes

If the LEDs display the high humidity signal, the humidity is
If the LEDs display the self-test (failure) signal, a fault
Hewlett-Packard DDS drives continually monitor the
Key
OFF
Steady Green
Steady Amber
Flashing Green
1/2 sec on, 1/2 sec off
Pulsing Amber
Fast Flash Green
1/4 sec on 1/4 sec off