Removing the Storage Tray
Before removing the Storage Tray Assembly, perform the procedures
described in Preparing to Install Your Storage Device on page 115.
NOTICE:
The Storage Tray Assembly does not have to be removed from the system
unit to access a hard disk drive or the 3.5-inch floppy drive.
If you are installing a hard disk or floppy drive, proceed directly to
Removing the Storage Tray Cover on page 120.
Perform the following steps to remove the storage tray assembly from the
Main Tray:
1 Pull the tab and slide the memory retainer toward the front of the main tray to re-
Figure 24
Removing the Memory Retainer
move it, as shown in Figure 24.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
117