Installing The Option Board; Removing The Option Board Support Bracket And Blank Plate - HP B132L+ Owner's Manual

Installing the Option Board

Before installing option boards you must perform the procedure described in
Removing the Main Tray Assembly on page 111.
Follow these steps to install a PCI, EISA, or GSC option board into your
workstation:
1 Push in the locking tab and slide the option board support bracket toward the rear
2 Remove the blank plate retaining screw, then remove the blank plate, as shown
Blank Plate
Figure 53

Removing the Option Board Support Bracket and Blank Plate

of the main tray to remove it, as shown in Figure 53.
in Figure 53.
Support Bracket
Changing Your Workstation's Hardware Configuration
Installing a PCI, EISA, or GSC Option Board
151