Removing the Main Tray Assembly
Perform the following steps to remove the Main Tray Assembly:
1 Shutdown and prepare the workstation as described in Preparing Your Worksta-
2 Disconnect all cables and connectors from the front and rear connectors of the
3 Attach a static-grounding wrist strap to bare metal on the back panel of the system
4 Remove the four thumbscrews on the rear of the system unit, as shown in Figure
Thumbscrews
Figure 21
5 Place one hand on the top of the system unit and push, while pulling the handle
6 Slide the main tray assembly out of the chassis.
tion earlier in this appendix.
system unit.
unit.
21.
Removing Main Tray Assembly
on the rear panel with your other hand. See Figure 21.
Changing Your Workstation's Hardware Configuration
Removing the Main Tray Assembly
Thumbscrews
111