View Scsi Options - HP MSL6000 Series User Manual

Table 6

View SCSI Options

Option
Drive 0 Bus ID
Drive 1 Bus ID
Drive 2 Bus ID
(four-drive models
only)
Drive 3 Bus ID
(four-drive models
only)
Library SCSI Bus ID
Library SCSI Bus Parity
Mail Slot Access
SCSI Mode
Unit Attention
Reporting
64 Operation
Description
Lets you set the SCSI addresses of drive 0. The designators
Drive 0 (outer tape drive) through Drive
n
through th drives, counting from right to left starting with
the master unit in a scaled Library system. Default is 1.
Lets you set the SCSI addresses of drive 1. The designators
Drive 1 (inner tape drive) through Drive
n
second through th drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 2.
Lets you set the SCSI addresses of drive 2. The designators
Drive 2 (lower, outer tape drive) through Drive
n
the third through th drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 3.
Lets you set the SCSI addresses of drive 3. The designators
Drive 3 (lower, inner tape drive) through Drive
n
the fourth through th drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 4.
Lets you set the SCSI addresses for the library robotics. The
default is 0.
Lets you enable or disable the library robotics SCSI bus
parity checking. The default is Enabled.
This option controls access to the mail slot and media
removal. "Prevent Allow" Command Inhibits allows access
to the mail slot via the GUI control panel and allows
media removal. "Prevent Allow" Command Ignored
prevents access to the mail slot and removal of media. This
option is used for some backup applications. The default is
"Prevent Allow" Command Inhibits.
Defines the loader as SCSI-2 or SCSI-3. The default is
SCSI-3.
Lets you select reporting of all or only one stacked-unit
attention conditions. If set to Report All, the unit reports all
unit attention conditions in sequence; if set to Report One,
the unit reports only the highest priority condition. The
default is Report All.
n
refer to the first
n
refer to the
n
refer to
n
refer to