HP MSL6000 Series User Manual page 105

Table 10 Fault Symptom Codes (continued)
FSC Message
1005 Illegal SCSI Cnt Cmd
(Either an invalid command was sent to
the SCSI controller, or the controller was
not in the correct mode.)
1007 SCSI Invalid Element
(Internal SCSI task processing error.
Invalid element type was detected.)
1008 SCSI No Pending Int.
1009 SCSI Invalid Int.
(The SCSI controller posted an invalid
interrupt status.)
100F SCSI Un-terminated Resets
(SCSI Continuous Resets Detected)
2004 Loader Not Ready
(Failed to fetch, stow, scan, move, pass
through, or loader detected invalid
command and aborted.)
2008 Illegal Move
2009 Door Open (status only)
(Door is forced open or door sensor
failed.)
ERP
• Turn off power to the library and inspect
connectors and cables.
• Check that application is certified to work
with your library and has up-to-date
patches.
• Ensure SCSI options are set correctly.
• Check the SCSI cable connections to
make sure they are secured.
• Make sure the library controller board
has SCSI termination.
• Check host SCSI cable and connections.
• Turn off power to the library and inspect
connectors and cables.
Check host SCSI cable and connections.
•
• Turn off power to the library and inspect
connectors and cables.
• Turn off power to the library and inspect
connectors and cables.
• Check host SCSI cable and connections.
• Verify that the library SCSI bus is
properly terminated.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
• Cycle power to the library or reboot
using the GUI touch screen.
• Verify the source and destination of the
move operation.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
• Invalid user initiated operation. Select
parameters correctly and try again.
• Make sure door(s) are closed.
• Press the Enter button to clear the
message.
MSL6000 series tape library user guide 105