Ultrium Cartridges; Sdlt Cartridges; Running A Cleaning Cartridge; Sdlt Buckle Leaders - HP MSL6000 Series User Manual

Do not use cartridges with:
• Tape or leaders that have been touched with bare fingers, as this may transfer oils to the tape
head.
• Labels used on the top, bottom, sides, or back of the cartridge. Use the label slot or recess only.
• More than one label applied, as extra labels can cause the cartridges to jam in the tape drive.

Ultrium Cartridges

CAUTION: Do not bulk erase Ultrium formatted cartridges. This will destroy pre-recorded servo
information, and make the cartridges unusable.

SDLT Cartridges

In addition to the general inspection listed on page 92, you can further determine if SDLT tapes
have been damaged by doing the following:
• Visually inspect the tape for a broken, unseated, or misaligned tape leader
page 93).
• Check the leader position by pressing in the door lock to release the cartridge door. While
pressing in the door lock, push the tab down to open the door. Be careful not to touch the tape
after opening the door. Ensure that the leader is in the correct position
Good
Figure 75

SDLT buckle leaders

Running a Cleaning Cartridge

Use the Clean Drive menu option contained in the Maintenance submenu of the Utilities area
on the front panel display to clean tape drives installed in HP StorageWorks MSL Series tape library.
Worn (Do Not Use)
(Figure 75
(Figure 75
MSL6000 series tape library user guide
on
on page 93).
93