HP MSL6000 Series User Manual page 109

Table 10 Fault Symptom Codes (continued)
FSC Message
20c0 Drive In Error
(Control failed to set SCSI ID.)
20c1 Drive In Error
(Control failed on installed drive.)
3000 Motor Fault Condition
(One of the robot motors has been
disabled and could not be re-enabled.)
3002 Picker Tach Errors
(Picker tachometer errors were detected
when checking slots.)
3005 Pass-thru Tach Errors
(Excessive Pass through elevator tach
errors.)
3011 Bin Fetch Failure
(Loader failed to fetch a cartridge from a
bin.)
ERP
Press the Enter button to clear the
•
message.
• Ensure the drive shows good status
through the drive status window.
• Check SCSI ID settings.
• Cycle power to the library or reboot
using the GUI touch screen.
Press the Enter button to clear the
•
message.
• Ensure the drive shows good status
through the drive status window.
• Check SCSI ID settings.
• Check cabling.
• Cycle power to the library or reboot
using the GUI touch screen.
Press the Enter button to reboot.
•
Cycle power to the library or reboot
•
using the GUI touch screen.
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
• Power down the library using the LCD
touch display.
• Remove Pass-through and check
connections.
Press the Enter button to reboot.
•
• Ensure cartridges are fully inserted in the
magazine(s).
• Ensure that there are no obstructions
inside the library (all cartridges are in
magazines).
• Run the cartridge cycle diagnostic to
verify.
Check the tape cartridge used in the last
•
operation for damage.
MSL6000 series tape library user guide 109