HP MSL6000 Series User Manual page 127

Table 10 Fault Symptom Codes (continued)
FSC Message
7002 Control command execution failed
7003 Control response not matched to a known
command
7004 Loader response not matched to a known
command
7005 Drive response not matched to a known
command
7006 Flash response not matched to a known
command
7007 Drive index on Update Status message
was invalid
7008 The Drive response was not as expected
7009 The opcode for a WORD message was
unknown
700A The opcode for a DWORD message was
unknown
700B The button causing library to go offline
was unknown
(A command to take the library off-line
was completed successfully, but the GUI
button that initiated the action could not
be identified.)
ERP
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
• Press the Enter button to reboot.
• Cycle power to the library or reboot
using the GUI touch screen.
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
• Press the Enter button to reboot.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
Press the Enter button to reboot.
•
• Cycle power to the library or reboot
using the GUI touch screen.
• Press the Enter button to reboot.
• Cycle power to the library or reboot
using the GUI touch screen.
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
MSL6000 series tape library user guide 127