HP MSL6000 Series User Manual page 114

Table 10 Fault Symptom Codes (continued)
FSC Message
3033 Chassis S/N did not scan
(A valid serial number bar code label
could not be read.)
3034 Chassis S/N save operation failed
(The serial number scanned from the bar
code label could not be saved to
non-volatile memory.)
3035 Drive Unload Prevented
(The drive prevented media removal
barcode on cartridge in drive could not
be read.)
3040 Motor Firmware Error
(The loader task detected an unexpected
status and could not recover.)
3041 Loader Received Invalid Command
(The loader task received an unexpected
command and could not recover.)
3042 Motor Firmware Error
(The loader task detected an unexpected
status and could not recover.)
3050 Missing Magazine
(In diag, no magazine installed for diag
to run.)
3051 No Cartridges In Library
(No cartridge available for diag to run.)
3052 Too Many Cartridges
(Unable to run cartridge or drive cycle
because loader is full with cartridges.)
114 Troubleshooting
ERP
Press the Enter button to clear the
•
message.
• Contact support.
Press the Enter button to clear the
•
message.
• Contact support.
• Remove the cartridge from the library via
the Move Media using the LCD touch
display.
• Inspect/replace the barcode label if
necessary.
• Press the Enter button to reboot.
• Turn off power to the library and inspect
connectors and cables.
• Press the Enter button to reboot.
• Turn off power to the library and inspect
connectors and cables.
• Press the Enter button to reboot.
• Turn off power to the library and inspect
connectors and cables.
• Press the Enter button to clear the
message.
• Insert magazine.
• Invalid user initiated operation. Set
parameters correctly and try again.
Press the Enter button to clear the
•
message.
• Insert cartridge.
• Invalid user initiated operation. Set
parameters correctly and try again.
Press the Enter button to clear the
•
message.
• Remove a tape from the library.
• Invalid user initiated operation. Set
parameters correctly and try again.