Extension Caller Id - Panasonic KX-TAW848 Features Manual

Programming References
4.7.11 Extension Port [1-5]
Feature Guide References
None
Extension Number
Specifies the extension number of the extension.
To change the extension number of a wired extension, follow the steps below:
1.
Type the new extension number, then click Apply.
2.
Set the status of the extension port to "OUS", then "INS".
When changing the extension number, make sure that the extension port is not in use. If the extension
number is changed while the port is in use, the new extension number will not come into effect.
Default
Starting at 101 (For port 01 of the first extension card that is installed. Extension numbers are preset for
subsequent extensions by adding one to the previous extension number.)
Value Range
Max. 4 digits (consisting of 0–9)
Programming References
4.7.12 Extension Port [1-5] Port Command
Feature Guide References
None
Extension Name
Specifies the name of the extension. As for the available characters, refer to the character code table
described in section 3.2.1 Installing and Starting KX-TAW848 Maintenance Console.
Default
Not stored.
Value Range
Max. 20 characters
Feature Guide References
None

Extension Caller ID

Enables the extension to send Caller ID information to an SLT.
Note that the setting of this parameter is only effective when a resource for sending extension Caller ID is
assigned in Extension Caller ID Resource-1, 2 for the port in Extension Caller ID [2-11].
4.10 Extension [4]
Feature Guide 449