Table of Contents
Advertisement
Power switch on but fryer
completely inoperative
Pressure not exhausting at
end of Cook Cycle
Operating pressure too high
Pressure does not build
Shortening not heating
Foaming or boiling over
Shortening not draining
Filter motor won't run
4-1
• Open circuit
• Solenoid or exhaust line clogged
• Deadweight clogged
• Not enough product in frypot
• Metal shipping spacer not
removed from deadweight
• Pressure not programmed
• Lid gasket leaking
• Drain valve open
• High temperature limit tripped
• See Boil-Over chart on fryer
and beginning of Operation
Section in this manual
• Drain valve clogged
• Motor overheated
Model PFE- 591
• Fryer plugged in
• Check breaker or fuse at wall
• Turn off and allow fryer to cool to
release the pressure in frypot; have
all lines, solenoid and exhaust tank
cleaned
• Turn off and allow fryer to cool to
release the pressure in frypot; clean
deadweight; See Preventive Mainte-
nance Section
• Place full capacity product in frypot
when using fresh shortening.
• Remove shipping spacer; see
Unpacking Instructions Section
• Check programming
• Reverse or replace lid gasket
• Close drain valve.
• Reset high temperature limit; see
Operating Components Section
• Follow Boil-Over procedures from
chart
• Push cleaning rod through open
drain valve
• Reset motor; see Filter Pump Motor
Protector-Manual Reset Section
703
Advertisement
Table of Contents
