Table of Contents
Advertisement
3-16. SPECIAL PROGRAM
MODE (Continued)
3-42
Manager Code Change (SP-15)
This allows the operator to change the program code, or manager
code (factory set at 1, 2, 3) used to access Product
Programming, Special Programming, Clock Set, Data Comm,
and Heat Control Modes.
a. Follows steps 1 and 2 above.
b.Press
until "SP-15" and "CHANGE, MGR CODE?
1=YES" shows in display, along with "CODE".
c. Press
. "ENTER NEW CODE, P=DONE, I=QUIT"
shows in display. Press Product buttons with new code.
d.If satisfied with code, press
CODE, P=DONE, I=QUIT, shows in display. Press same
code buttons in step c.
e. If satisfied with code, press
shows in display.
f. If not satisfied with code, press
shows in display, then reverts back to "SP-15" and
"CHANGE, MGR CODE, 1=YES". Then the above steps
can be repeated.
Usage Code Change (SP-16)
This allows the operator to change the usage code(factory set at
1, 2, 3) used to reset the usage data in the Information Mode.
a. Follows steps 1 and 2 above.
b.Press
until "SP-16" and "CHANGE, USG CODE?
1=YES" shows in display, along with "CODE".
c. Press
. "ENTER NEW CODE, P=DONE, I=QUIT"
shows in display. Press Product buttons with new code.
d.If satisfied with code, press
CODE, P=DONE, I=QUIT, shows in display. Press same
code buttons in step c.
e. If satisfied with code, press
shows in display.
f. If not satisfied with code, press
shows in display, then reverts back to "SP-16" and
"CHANGE, USG CODE, 1=YES". Then the above steps
can be repeated.
Model PFE- 591
. "REPEAT NEW
. *CODE CHANGE*
and "*CANCELLED*"
. "REPEAT NEW
. "*CODE CHANGE*"
and "*CANCELLED*"
403
Advertisement
Table of Contents
