Configuring Network Settings (Configuration > Configure Network Settings) - HP StorageWorks 1/8 User's And Service Manual

5. Repeat Step 5 until all numbers in the date are correct. Press Enter.
6. The screen displays (example) Set Hour / Mins 16 : 52 with the first number flashing. Press
Previous or Next until the flashing number reads correctly. Press Enter to move to the next number.
Repeat this step until all numbers in the time are correct. Press Enter.
Configuring network settings (Configuration > Configure Network Settings)
The device can automatically obtain an IP address from a DHCP server when the device is powered
on. The device also supports user-specified fixed addresses through the front panel.
The device also supports SNMP. You can enable SNMP and configure the target addresses with the
RMI. See Changing the network
To configure IPv4 network settings:
1. From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2. Press Previous or Next until the screen displays Configure Network Settings. Press Enter to select.
3. Press Previous or Next until the screen displays IPv4 Networking Enabled. Press Enter to select.
4. Press Previous or Next until the screen displays DHCP Enabled. To change the setting, press Enter.
Press Next until the screen shows the desired setting. Press Enter to accept the new setting.
5. If DHCP is disabled, press Previous or Next until the screen displays IP Address. The second line
displays the current IP address.
6. To change the IP address, press Enter. The screen displays Set IP Address with the first number
flashing. Press Previous or Next to change the flashing number to the correct value.
7. Press Enter to select the next number, until all numbers have been set. The screen displays New
IP Address.
8. Press Previous or Next until the screen displays Subnet Mask Address. To change the Subnet
Mask Address, press Enter. The screen displays Set Subnet Mask Address, with the first number
flashing.
9. Press Previous or Next to change the flashing number to the correct value. Press Enter to select
the next number.
10. Repeat Step 9 until all numbers have been set. The screen displays New Subnet Address.
11. Press Previous or Next until the screen displays Gateway Address. To change the Gateway
Address, press Enter. The screen displays Set Gateway Addr, with the first number flashing.
12. Press Previous or Next to change the flashing number to the correct value. Press Enter to select
the next number.
13. Repeat Step 12 until all numbers have been set. The screen displays New Gateway Addr. Press
Enter.
To enable IPv6:
1. From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2. Press Previous or Next until the screen displays Configure Network Settings. Press Enter to select.
3. Press Previous or Next until the screen displays IPv6 Networking. Press Enter to select.
4. The screen displays IPv6 Network Addressing Disabled. To change the setting, press Enter.
5. Press Next until the screen displays the desired setting. Press Enter to accept the new setting.
94 Operating the Tape Autoloader
configuration" on page 65.