Removing And Replacing The Base Chassis; Removing The Left Magazine - HP StorageWorks 1/8 User's And Service Manual

2. Push a small metal pin or paper clip about 1.5 cm (0.6 inch) into the appropriate release hole
to push on the release latch (see
removes it from the Autoloader.
Figure 81 Removing the left magazine
.
1.
2.
IMPORTANT:
Do not force the pin once you encounter resistance. Doing so can damage the Autoloader.

Removing and replacing the base chassis

In this process you will:
• Record configuration settings.
• Remove the tape cartridge from the tape drive.
• Remove the cables, drives, and magazines from the Autoloader.
• Remove the Autoloader from the rack or tabletop conversion cover.
• Replace the base chassis.
• Reinstall the Autoloader into the rack or tabletop conversion cover if the support feet have not
been applied.
• Replace the cables, tape drive, and magazines.
• Reconfigure the Autoloader.
WARNING!
The HP StorageWorks 1/8 G2 Tape Autoloader weighs 11.5 kg (25.4 lb) without media and 13.1
kg (28.9 lb) with media (8 cartridges). When moving the Autoloader, to reduce the risk of personal
injury or damage to the Autoloader: 1) observe local health and safety requirements and guidelines
for manual material handing, 2) always remove all tapes to reduce the overall weight of the Autoloader,
and 3) obtain adequate assistance to lift and stabilize the Autoloader during installation or removal.
Figure
Insert a pin into access hole
Release and remove the magazine
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide
81) while another person grasps the magazine and
163