Operator Control Panel (Ocp) - HP StorageWorks 1/8 User's And Service Manual

Operator control panel (OCP)

The operator control panel on the front of the device includes a 2-line by 16-character green backlit
liquid crystal display (LCD), four function keys, and four LEDs. This panel provides everything you
need to monitor the device status and control its functions.
The following functions are available through the OCP:
• Unlocking the mailslot (Unlock
• Status/Information" on page 86
• Inventory (Status/Information >
• Autoloader information (Status/Information > Autoloader
• Drive information (Status/Information > Drive
• Component status (Status/Information > Component
• Network information (Status/Information > Network
• Configuration" on page 89
• Changing the administrator password (Configuration > Change Admin
90
• Setting the number of reserved slots (Configuration > Set Reserved Slot
• Configuring the mailslot (Configuration > Configure
• Bar code reporting format (Configuration > Barcode Format
• Changing the SCSI address — parallel SCSI devices (Configuration > Change
92
• Setting behaviors (Configuration > Autoloader
• Setting the date and time (Configuration > Autoloader
• Configuring network settings (Configuration > Configure Network
• Configuring automatic cleaning (Configuration > Configure Auto
• Restoring factory defaults (Configuration > Restore
• Saving and restoring the Autoloader configuration (Configuration > Save/Restore Configura-
tion)" on page 96
• Operations" on page 97
• Unlocking, removing, and replacing magazines (Operations > Unlock Left or Right
Magazine)" on page 97
• Cleaning the tape drive (Operations> Clean
• Moving tapes in the Autoloader (Operations > Move
• Updating tape cartridge inventory (Operations > Perform
• Rebooting the Autoloader (Operations> Reboot
• Enabling password locks (Operations > Enable Autoldr Password
• Support" on page 100
• Powering a drive on or off (Support > Power On/Off
• Running the demonstration (Support > Run
• Running the slot to slot test (Support > Run Slot To Slot
• Running the wellness test (Support > Run Wellness
• Upgrading firmware (Support > Autoloader FW Upgrade, Support > Drive FW Up-
grade)" on page 103
• Forcing the drive to eject a tape (Support > Force Drive To Eject
Mailslot)" on page 86
Inventory)" on page 87
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide
Information)" on page 88
Information)" on page 88
Status)" on page 89
Information)" on page 89
Mailslot)" on page 91
Reporting)" on page 91
Behavior)" on page 92
Date/Time)" on page 93
Cleaning)" on page 95
Defaults)" on page 95
Drive)" on page 97
Tape)" on page 98
Inventory)" on page 99
Autoloader)" on page 100
Locks)" on page 100
Drive)" on page 101
Demo)" on page 101
Test)" on page 101
Test)" on page 102
Tape)" on page 105
Password)" on page
Count)" on page 90
Drive)" on page
Settings)" on page 94
81