HP StorageWorks 1/8 User's And Service Manual: Changing The Administrator Password (configuration > Change Admin Password); Setting The Number Of Reserved Slots (configuration > Set Reserved Slot Count)

G2 tape autoloader.
Hide thumbs

Advertisement

Setting the number of reserved slots (Configuration > Set Reserved Slot
Configuring the mailslot (Configuration > Configure
Bar code reporting format (Configuration > Barcode Format
Changing the SCSI address — parallel SCSI devices (Configuration > Change
Setting behaviors (Configuration > Autoloader
Setting the date and time (Configuration > Autoloader
Configuring network settings (Configuration > Configure Network
Configuring automatic cleaning (Configuration > Configure Auto
Restoring factory defaults (Configuration > Restore
Saving and restoring the Autoloader configuration (Configuration > Save/Restore Configura-
tion)" on page 96
To access the Configuration menu:
1.
From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2.
Press Previous or Next until the screen displays your selected function. Press Enter to select.
Changing the administrator password (Configuration > Change Admin Password)
Use Change Admin Password to set or change the administrator password. Once the administrator
password is set, you must know the administrator password or the service password to change the
administrator password. Passwords consist of exactly eight numbers each between the values of 0
and 9.
Screens that require a password prompt for the password before allowing access to the restricted
areas. Once entered, the administrator password does not have to be entered a second time unless
there is no user activity for five minutes. Enter the administrator password if you are prompted to do
so.
To change the administrator password:
1.
From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2.
Press Previous or Next until the screen displays Change Admin Password. Press Enter to select.
3.
The first number is flashing. Press Previous or Next to change the value of the flashing number.
When the flashing number shows the desired value, press Enter to select.
4.
The screen displays the second number flashing. Repeat Step 3 until you have entered all eight
characters. Press Enter to select. After the last number has been entered, the password has been
set to the new password.
NOTE:
If you forget the administrator password, you cannot enter a new password. You must call your
customer service representative.
Setting the number of reserved slots (Configuration > Set Reserved Slot Count)
Reserved slots can be accessed by the remote management interface (RMI) and the operator control
panel (OCP), but are invisible to the host and backup software. For example, you might keep a
90
Operating the Tape Autoloader
Count)" on page 90
Mailslot)" on page 91
Reporting)" on page 91
Behavior)" on page 92
Date/Time)" on page 93
Settings)" on page 94
Cleaning)" on page 95
Defaults)" on page 95
Drive)" on page 92

Advertisement

   Also See for HP StorageWorks 1/8

   Related Manuals for HP StorageWorks 1/8

This manual also for:

Hdx 18

Comments to this Manuals

Symbols: 0
Latest comments: