HP StorageWorks 1/8 User's And Service Manual: Operations; Moving Media

G2 tape autoloader.
Hide thumbs

Advertisement

The following settings are not reset:
Administrator password
Network settings (network is always enabled and the network addresses are retained)
Date and time
To save the device configuration to a file, click Save and follow the instructions on the RMI to specify
a file location.
To restore the device configuration from a file, browse to the location of the saved configuration file
and click Restore.
The configuration settings that are saved to file are:
Administrator password
Mailslot configuration
All network settings, including DHCP, DNS, IPv4 and IPv6 addresses
Barcode reader label length and barcode reader alignment
Reserved slots
Autoloader mode
All drive configuration settings
Auto clean
SNMP addresses and configurations
Log tracing configuration
Email notification configuration (SMTP address, email address, filter level)
Option to allow the magazine access without the administrator password
Option to ignore the barcode media ID
Encryption and security settings

Operations

Moving media
Use the
Operations: Move Media page
IMPORTANT:
Moving media manually can interfere with backup software operations. Ensure backups are complete
before moving media.
74
Operating the Tape Autoloader
to move tape cartridges within the device.

Advertisement

   Also See for HP StorageWorks 1/8

   Related Manuals for HP StorageWorks 1/8

This manual also for:

Hdx 18

Comments to this Manuals

Symbols: 0
Latest comments: