Powering A Drive On Or Off (Support > Power On/Off Drive); Running Slot To Slot Test; Running The Demonstration (Support > Run Demo); Running The Slot To Slot Test (Support > Run Slot To Slot Test) - HP StorageWorks 1/8 User's And Service Manual

1. From the Home screen, press Previous or Next until the screen displays Support. Press Enter to
select.
2. Press Previous or Next until the screen displays your selected function. Press Enter to select.
Powering a drive on or off (Support > Power On/Off Drive)
Use this option to power a drive on or off without interrupting power to the rest of the device. Access
to this feature requires the administrator password.
To power on or off the drive:
1. From the Home screen, press Previous or Next until the screen displays Support. Press Enter to
select.
2. Press Previous or Next until the screen displays Power On/Off Drive. Press Enter to select.
3. Enter the administrator password, if prompted.
4. The screen displays Drive. The second line in the display displays the current state, which is either
Power ON or Power OFF.
5. To change the power status, press Enter. The screen displays either Press Enter to Power off Drive,
or Press Enter to Power on Drive. Press Enter to select. The Ready LED blinks during the operations.
Running the demonstration (Support > Run Demo)
Use this option to run a device demonstration program. The demonstration continues until the Cancel
button is pressed on the operator control panel. During the demonstration the device will move
cartridges to the tape drive and back. At the end of the demonstration the cartridges are returned to
their original slots. Access to this feature requires the administrator password.
To run the demonstration:
1. From the Home screen, press Previous or Next until the screen displays Support. Press Enter to
select.
2. Press Previous or Next until the screen displays Run Demo. Press Enter to select.
3. Enter the administrator password if prompted.
4. Use Previous and Next to select the number of cycles: 270, 540, 1080, or Endless. Press Enter
to start the demonstration.
5. While the test is running, the first line of the screen displays Demo Test. The second line displays
the number of cycles completed and the number of errors. The Ready LED blinks until the test is
complete.
NOTE:
To stop the demonstration, press Cancel on the operator control panel.
Running the slot to slot test (Support > Run Slot To Slot Test)
Use this option to show the robot's ability to move media in and out of each of the magazine slots.
Access to this feature requires the administrator password.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 101