Download Print this page

HP StorageWorks 1/8 User's And Service Manual: Saving And Restoring The Autoloader Configuration (configuration > Save/restore Configuration)

G2 tape autoloader.
Hide thumbs

Advertisement

The following settings are not reset:
Administrator password
Network settings (network is always enabled)
Date and time
To restore the factory defaults:
1.
From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2.
Press Previous or Next until the screen displays Restore Defaults. Press Enter to select.
Saving and restoring the Autoloader configuration (Configuration > Save/Restore
Configuration)
Use this option to save the configuration settings to a USB flash drive. The saved configuration
information will make it easier to recover the device configuration if you need to replace the chassis.
This feature is also useful when installing multiple devices. Either save the configuration before
configuring the network or ensure that only one device with the same network configuration is on the
network at a time until they have unique network identities.
To save the device configuration settings to a USB flash drive:
1.
Insert the USB flash drive in the USB port on the back of the device.
2.
From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
3.
Press Previous or Next until the screen displays Save/Restore Configuration. Press Enter to select.
4.
Enter the administrator password if prompted.
5.
The screen displays Save Configuration to USB. Press Enter to save.
6.
When the save operation is completed, remove the USB flash drive from the USB port.
To restore the device configuration settings from a USB flash drive:
1.
Insert the USB flash drive in the USB port on the back of the device.
2.
From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
3.
Press Previous or Next until the screen displays Save/Restore Configuration. Press Enter to select.
4.
Enter the administrator password if prompted.
5.
Press Previous or Next until the screen displays Restore Config from USB. Press Enter.
6.
Press Previous or Next until the screen displays the filename of the device configuration file on
the USB drive. Press Enter to select the firmware file.
7.
When the restore operation is completed, remove the USB flash drive from the USB port.
NOTE:
You can save the configuration settings to a file from the RMI. See
configuration and restoring factory
96
Operating the Tape Autoloader
defaults" on page 72
Saving and restoring the device

Advertisement

Table Of Contents

   Also See for HP StorageWorks 1/8

   Related Manuals for HP StorageWorks 1/8

This manual also for:

Hdx 18

Comments to this Manuals

Symbols: 0
Latest comments: