Rack Kit; Installing The Rails Into The Rack - HP StorageWorks 1/8 User's And Service Manual

Figure 12 Rack kit
.
• Two rails
• Two bags of eight M6 screws.
Select the bag of screws appropriate for your type of rack.
• The HP Rack System/E rack has 7.1 mm round holes in the rack column. The packet for this rack
type is labeled HP Rack System/E.
• The HP Rack 5000 and 10000 series have 9.5 mm square holes in the rack column. The packet
for these rack types is labeled HP Rack 5000, 10000 Series.
To install the rails into the rack:
1. Using the screws for your rack type and a #3 Phillips screwdriver, secure one rail to each side
of the rack in your chosen rack location.
2. Secure the front of one rail to the front of the rack. Extend the rail to the depth of the rack and
secure the rail to the back of the rack. The front of the rails are straight and the back are angled,
as shown in Figure 13
Figure 13 Installing the rails into the rack
.
To install the device on the rails and into the rack:
1. Locate the captive screws on the front bezel (see
2. Slide the device onto the rails.
36 Installing the Tape Autoloader
on page 36.
Figure 14).