San Connection; Choosing A Location; Location Criteria - HP StorageWorks 1/8 User's And Service Manual

Check the EBS matrix at http://www.hp.com/go/ebs to verify that your HBA is supported on your
server and qualified for the Autoloader.
A server that uses Fibre Channel disks needs at least two FC ports. Using the same port for disk and
tape access will cause performance degradation.

SAN connection

All switches between the host and the Autoloader must be of the appropriate type. A 2 Gb switch in
the path may result in performance degradation when backing up highly compressible data.
Configure zoning on the Fibre switch so only the backup servers may access the Autoloader. See the
switch manual for information on zoning.

Choosing a location

If you plan to mount the device in a rack, select an open rack location, ideally near the center of the
rack or higher, with access to the host server and a power outlet. You may also set the Autoloader
on a shelf in the rack. In this case you must attach the feet during the installation process.
If you plan to set the Autoloader on a table, select a level area large enough to support both edges
of the Autoloader with access to the host server and a power outlet.
Choose a location that meets the criteria shown in
Table 10 Location criteria
Criteria
Tabletop
requirements
Rack requirements
Rack space
requirements
Room temperature
Power source
Weight without
media
Weight with media
Definition
The Autoloader can only be placed on a flat surface if the support feet have been
properly applied or the Autoloader is mounted in the optional tabletop conversion
cover. Select a location that is flat, sturdy, and close to the host server. Ensure that all
of the feet on the Autoloader or tabletop conversion cover will be supported.
Do not place the device on the floor or other carpeted surface.
Do not place the Autoloader on its sides or upside down. Do not put anything on top
of the Autoloader unless the optional tabletop conversion cover is installed. The tabletop
conversion cover can support up to 15 kg (33 lb).
HP Rack 5000, 10000 Series, HP Rack System/E
1U when mounted in the optional rack rails
10-35º C (50-95º F)
AC power voltage: 100-127 VAC; 200-240 VAC
Line frequency: 50-60 Hz
Place the device near an AC outlet. The AC power cord is the product's main AC
disconnect device and must be easily accessible at all times.
11.5 kg (25.4 lb)
13.1 kg (28.9 lb)
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide
Table 10 on page 31:
31