Setting Error Log Mode; Configuration: Date/Time Page - HP StorageWorks 1/8 User's And Service Manual

Figure 43 Configuration: Date/Time page
.
You may change the:
• Time — configures the hours, minutes, and seconds for the internal clock. The time is based on a
24-hour clock, where 1:00 pm is 13:00.
• Date — configures the current month, day, and year for the internal clock.
• Enable Clock Synchronization — When enabled, the device will use the configured Simplified
Network Time Protocol (SNTP) service to obtain the current date and time.
• SNTP Server Address — the IP address of an SNTP server. The SNTP server may be configured
with either an IPv4 or IPv6 address, or with a host and domain name. If a host and domain name
are entered, the IP address will be resolved from the DNS using that name. The device will store
the resulting address, rather than the name. If the address changes, enter the name or a new ad-
dress so the device can find the server again.
• UTC Time Zone Offset — Select the time zone for your area.
• Enable Daylight Savings Adjustment — Enabling daylight saving time will advance the local time
by one hour. This setting does NOT automatically adjust the device time for daylight saving time
based on the calendar. You must manually enable this setting when daylight saving time starts in
your area and disable it when daylight saving time ends.

Setting error log mode

The Configuration: Log page can only be accessed by HP Service personnel.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 71