Remaining System Installation
M68EM05P18UM/D
MOTOROLA
When you have configured headers W1 and W2 and set switch SW1,
M68EM05P18 configuration is complete:
•
Ensure that the power to the development tool is off.
•
If installing the M68EM05P18 in an MMDS05 station module,
remove the panel from the station module top.
•
Fit together EM connectors P1 and P2 (on the bottom of the board)
and platform board DIN connectors. Snap the corners of the EM
onto the plastic standoffs.
•
Connect the target cable, if appropriate.
•
If installing in an MMDS05, replace the panel.
At this point, you are ready to make remaining cable connections, as
necessary, and restore power.
For instructions, consult either the MMEVS05/MMEVS08 Operations
Manual (MMEVS0508OM/D) or the MMDS05 Operations Manual
(MMDS05OM/D).
MMDS/MMEVS Configuration and Operation
MMDS/MMEVS Configuration and Operation
Remaining System Installation
25