Table of Contents
Advertisement
Introduction
This chapter provides unpacking instructions, hardware preparation, and
installation instructions for the MVME197LE VMEmodule. The MVME712X
transition module hardware preparation is provided in separate manuals,
refer to the Related Documentation section found in the preface part of this
User's Manual.
Unpacking Instructions
N
If shipping carton is damaged upon receipt, request that the
ote
carrier's agent be present during unpacking and inspection
of equipment.
Carefully unpack the equipment from the shipping carton. Refer to the
packing list and verify that all items are present. Save the shipping carton and
packing materials for storing or reshipping of the equipment.
C
Avoid touching areas of integrated circuits. Static discharge
aution
can damage these components.
Inspect the equipment for any shipping damage. If no damage exists, then the
module can be prepared for operation according to the following sections of
this chapter.
Hardware Preparation
To select the desired configuration and ensure proper operation of the
MVME197LE module, certain modifications may be necessary before
installation. These modifications are made through switch settings as
described in the following sections. Many other modifications are done by
setting bits in control registers after the MVME197LE has been installed in a
system. (The MVME197LE registers are described in the MVME197LE,
MVME197DP, and MVME197SP Single Board Computers Programmer's Reference
Guide as listed in the Related Documentation section of this manual).
MVME197LE/D22-1
HARDWARE PREPARATION
AND INSTALLATION
2
Advertisement
Table of Contents
