Siemens Metro 21 M216KA Operator's Manual page 355

Configuration Frame and Parameterization
Frame for the ET 200L
Using STEP 7 as of
V 3.2 or
COM PROFIBUS
as of V 3.0
Using Any
Configuration
Software
Default Start-Up
Contents of the
Chapter
ET 200L, ET 200L-SC and ET 200L-SC IM-SC Distributed I/O Device
EWA 4NEB 780 6009-02c
If you configure and parameterize the ET 200L using STEP 7 or using
COM PROFIBUS as of V 3.0 (or COM ET 200 Windows as of Version 2.1),
you can call on an on-line help system for assistance with your entries.
You need only the information in Section C.5. If you want to run your
ET 200L-SC or ET 200L-SC IM-SC without parameterization, you will find
the default configuration for a default start-up in Section C.5.
If you enter the configuration of the ET 200L-SC or ET 200L-SC IM-SC us-
ing a configuration frame and a parameterization frame, you will find the
information you require in Section C.3/C.4.
If you run your ET 200L-SC or ET 200L-SC IM-SC without parameterization
(e.g. with S5-95U), you will find the default configuration for a default
start-up in Section C.5.
Note
When creating the configuration and parameterization frames, you must use
the predefined identifiers. If you use the wrong identifiers, the ET 200L-SC
or ET 200L-SC IM-SC cannot work properly.
The ET 200L-SC or ET 200L-SC IM-SC does not check all the contents of
the configuration and parameterization frames for plausibility.
Section
C.1 Identifiers for the ET 200L
C.2 Types of ET 200L-SC or ET 200L-SC IM-SC Start-Up
C.3 Configuration Frame for the ET 200L-SC or
ET 200L-SC IM-SC
C.4 Parameterization Frame for the ET 200L-SC or
ET 200L-SC IM-SC
C.5 Default Start-Up
Topic
C
Page
C-2
C-3
C-4
C-14
C-31
C-1