Installing The Node Power Distribution Board On The Sled Cover - Dell PowerEdge C8220X Hardware Owner's Manual

Figure 3-120. Removing and Installing the Node Power Distribution Board
9
8
1 M3 screws (4)
3 power cable
5 power cable
7 power cable
9 power cable

Installing the Node Power Distribution Board on the Sled Cover

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Insert the NPDB into the right retaining clip at a 45-degree angle, and
then press the other end of the board down into the left retaining clip to
secure the board in place. Make sure to align the NPDB with the screw
holes on the bracket. See Figure 3-120.
2 Replace the four screws securing the NPDB to the NPDB assembly. See
Figure 3-120.
320
Installing System Components
1
7
Many repairs may only be done by a certified service technician. You
3
4
2
2 emergency throttling cable
4 power cable
6 node power distribution board
8 power cable
5
6