Hard-Drive LED Board Assembly
Removing the Hard-Drive LED Board Assembly
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 176.
3 Remove the three screws securing the hard-drive LED board assembly.
See Figure 3-33.
4 Pull the hard-drive LED board assembly away from the front cover.
See Figure 3-33.
Figure 3-33. Removing and Installing the Hard-Drive LED Board Assembly
1
1
M3 screws (3)
2
hard-drive LED board assembly
Installing System Components
2
189