System Board V1.2 Jumper Settings
Figure 5-3. System Board V1.2 Jumper Settings
Table 5-3. System Board Jumper Settings
Item
Jumper
1
Service mode
2
NVRAM clear
3
ME firmware
recovery
4
BIOS recovery
1
2
3
4
6
5
Setting
(default) The flash security setting is enabled.
(default) The configuration settings are retained at
(default) The ME firmware recovery jumper is
(default) The BIOS recovery jumper is disabled.
Description
The flash security and NVRAM clear
signal is disabled.
system boot.
The configuration settings are cleared at
the next system boot.
disabled.
The ME firmware recovery jumper
enables ME firmware recovery mode.
The BIOS recovery jumper enables the
BIOS flash memory special recovery
mode.
Jumpers and Connectors
353