Installing The Sas Mezzanine Card - Dell PowerEdge C8220X Hardware Owner's Manual

Installing the SAS Mezzanine Card

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the SAS mezzanine card with the screw holes on the bracket.
See Figure 3-104.
2 Replace the three screws securing the SAS mezzanine card to the bracket.
See Figure 3-104.
3 Install the mezzanine card bridge board into the mezzanine slot on the
SAS mezzanine card. See Figure 3-103.
4 Connect all cables to the SAS mezzanine card. See Figure 3-105 or
Figure 3-106 cable routing diagram.
5 Replace the screw securing the mezzanine card bridge board to the
bracket. See Figure 3-103.
6 Lower the SAS mezzanine card assembly to the sled tray. See Figure 3-102.
7 Replace the two screws securing the SAS mezzanine card assembly to the
sled tray. See Figure 3-102.
8 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180 or "Installing the Sled Cover" on page 183.
9 Replace the sled. See "Installing a Sled" on page 156.
Installing System Components
297