Installing The Expansion Card Riser - Dell PowerEdge C8220X Hardware Owner's Manual

3 If applicable, remove the expansion card or RAID controller card. See
"Removing the MegaRAID SAS 9265-8i RAID Controller Card" on
page 192 or "Removing the MegaRAID SAS 9285CV-8e RAID Controller
Card" on page 198.
4 Remove the two screws securing the expansion card riser. See Figure 3-45.
5 Remove the expansion card riser from the front cover. See Figure 3-45.
Figure 3-45. Removing and Installing the Expansion Card Riser
1 M3 screws (2)

Installing the Expansion Card Riser

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Place the expansion card riser into the front cover. See Figure 3-45.
2 Replace the two screws securing the expansion card riser. See Figure 3-45.
3 Install the new expansion card or RAID controller card to one of the
expansion card riser connectors. See"Expansion Card Riser Connectors" on
page 363.
208
Installing System Components
1
Many repairs may only be done by a certified service technician. You
2
2 expansion card riser