Removing The Raid Battery Holder - Dell PowerEdge C8220X Hardware Owner's Manual

5 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180.
6 Replace the sled. See "Installing a Sled" on page 156.

Removing the RAID Battery Holder

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 176.
3 Remove the RAID battery. See "Removing the MegaRAID SAS 9285CV-8e
RAID Battery" on page 203.
4 Remove the three screws and hex nuts securing the battery holder to the
mounting board. See Figure 3-43.
5 Remove the battery holder. See Figure 3-43.
Figure 3-43. Removing and Installing the Battery Holder
1
4
Installing System Components
2
3
205