System Board Jumper Settings
This section describes the jumper options and settings available on system
board v1.0, v1.1 and v1.2.
System Board V1.0 Jumper Settings
Figure 5-1. System Board V1.0 Jumper Settings
Table 5-1. System Board Jumper Settings
Item
Jumper
1
Service mode
2
NVRAM clear
3
ME firmware
recovery
350
Jumpers and Connectors
Setting
(default) The flash security setting is enabled.
(default) The configuration settings are retained at
(default) The ME firmware recovery jumper is
Description
The flash security and NVRAM clear
signal is disabled.
system boot.
The configuration settings are cleared at
the next system boot.
disabled.
The ME firmware recovery jumper
enables ME firmware recovery mode.