Installing The Back Gpgpu Card Riser - Dell PowerEdge C8220X Hardware Owner's Manual

Installing the Back GPGPU Card Riser

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
If you are installing a new GPGPU card riser, ensure that it is installed
on the sled cover with the proper screw holes. If the GPGPU card riser is not
installed with the correct screw holes, the GPGPU card will not seat properly into
the riser connector. See "Back GPGPU Card Riser Screw Locations" on page 269
for the location of the screw holes.
Back GPGPU Card Riser Screw Locations
The back GPGPU card riser has four screw holes (see Figure 3-89) and each
pair is marked "type A" and "type B" and can be used to mount a specific type
of GPGPU/Xeon Phi card.
Screw Hole Type
Type A
Type B
See "GPGPU/Xeon Phi Cards" on page 209 for more information.
• Intel Xeon Phi 5110P card
• Intel Xeon Phi 7120P card
• NVIDIA Tesla K10 GPGPU card
• NVIDIA Grid K2 GPGPU card
• NVIDIA Tesla K20 GPGPU card
GPGPU/Xeon Phi Card
Installing System Components
269