Figure 3-34. Removing and Installing the Hard-Drive LED Board
1
M3 screws (2)
3
hard-drive LED board
Installing the Hard-Drive LED Board
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Place the hard-drive LED board into the hard-drive LED board assembly.
See Figure 3-34.
2 Replace the two screws securing the hard-drive LED board. See
Figure 3-34.
3 Connect the hard-drive LED cable. See Figure 3-34.
4 Replace the hard-drive LED board assembly. See "Installing the Hard-
Drive LED Board Assembly" on page 190.
5 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180.
6 Replace the sled. See "Installing a Sled" on page 156.
2
1
3
2
hard-drive LED cable
Installing System Components
191