Removing The Megaraid Sas 9285Cv-8E Raid Controller Card - Dell PowerEdge C8220X Hardware Owner's Manual

5 Insert the card edge connector firmly into the riser connector until the
card is fully seated.
6 Close the expansion card latch and tighten the thumbscrew.
See Figure 3-35.
7 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180.
8 Replace the sled. See "Installing a Sled" on page 156.

Removing the MegaRAID SAS 9285CV-8e RAID Controller Card

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
card riser. Do not attempt to install expansion cards directly into the riser
connector on the system board.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 176.
3 Once the front cover is detached, turn it over to expose the RAID
controller card side.
4 Disconnect the RAID battery cable from the RAID controller card.
See Figure 3-39.
5 Loosen the thumbscrew and rotate the expansion card latch.
See Figure 3-39.
6 Grasp the RAID controller card by its edges and carefully remove it from
the expansion card riser. See Figure 3-39.
198
Installing System Components
Many repairs may only be done by a certified service technician. You
Expansion cards can only be installed in the slots on the expansion