Enabling Applications; Trunk Group; Figure 3-66: Applications Enabling - AudioCodes Mediant 1000 User Manual

3.3.5.2

Enabling Applications

The 'Applications Enabling' page allows you to enable the following applications:

Stand-Alone Survivability (SAS) application

IP-to-IP (IP2IP) application
Notes:

To enable an application:
1. Open the 'Applications Enabling' page (Configuration tab > Protocol Configuration
menu > Applications Enabling
2. Save the changes to the device's flash memory and then reset the device (refer to
''Saving Configuration''
3.3.5.3

Trunk Group

The Trunk Group submenu allows you to configure groups of channels called Trunk
Groups. This submenu includes the following page items

Trunk Group Table (refer to "Configuring the Trunk Group Table" on page 102)

Trunk Group Settings (refer to "
3.3.5.3.1 Configuring the Trunk Group Table
The 'Trunk Group Table' page allows you to define up to 120 Trunk Groups. This table
enables the device's channels by assigning them telephone numbers and other optional
attributes (e.g., Trunk Group IDs and Tel Profiles). Channels that are not defined in this
table are disabled. Trunk Groups are used for routing calls (Tel-to-IP and IP-to-Tel) for the
channels associated with the Trunk Group.
Note:
SIP User's Manual
•
This page displays the application only if the device is installed with the
relevant Software Upgrade Key supporting the application (refer to
''Loading a Software Upgrade Key''
•
The IP2P application is applicable only to Mediant 1000.
•
For enabling an application, a device reset is required.
Figure 3-66: Applications Enabling Page
on page
Configuring Trunk Group Settings''
You can also configure Trunk Groups using the ini file table parameter
TrunkGroup_x to (refer to ''Number Manipulation and Routing Parameters''
page 428 ).
on page
page item).
199 ).
:
102
Mediant 600 & Mediant 1000
202 ).
on page 104 )
Document #: LTRT-83306
on