To add Proxy servers and configure Proxy parameters:
1.
Open the 'Proxy Sets Table' page (Configuration tab > Protocol Configuration
menu > Proxies, Registration, IP Groups submenu > Proxy Sets Table
2.
From the Proxy Set ID drop-down list, select an ID for the desired group.
3.
Configure the Proxy parameters according to the following table.
4.
Click the Submit
5.
To save the changes to flash memory, refer to ''
Parameter
Web: Proxy Set ID
EMS: Index
[ProxySet_Index]
SIP User's Manual
Figure 3-76: Proxy Sets Table Page
button to save your changes.
Table 3-22: Proxy Sets Table Parameters
The Proxy Set identification number.
The valid range is 0 to 9 (i.e., up to ten Proxy Set ID's can be
configured). The Proxy Set ID 0 is used as the default Proxy Set.
Note: Although not recommended, you can use both default Proxy
Set (ID 0) and IP Groups for call routing. For example, on the
'Trunk Group Settings' page (refer to ''Configuring Trunk Group
Settings''
on page
where you want to route specific Trunk Group's channels, while all
other device channels use the default Proxy Set. At the same, you
can also use IP Groups in the 'Outbound IP Routing Table' (refer to
''Configuring the Outbound IP Routing Table''
configure the default Proxy Set if the parameter PreferRouteTable
is set to 1.
To summarize, if the default Proxy Set is used, the INVITE
message is sent according to the following preferences:
To the Trunk Group's Serving IP Group ID, as defined in the
124
Mediant 600 & Mediant 1000
Saving Configuration''
Description
104
) you can configure a Serving IP Group to
Document #: LTRT-83306
page item).
on page
199
.
on page
158
) to