Application Network Setting; Figure 3-70: Dtmf & Dialing - AudioCodes Mediant 1000 User Manual

3.3.5.4.2 Configuring DTMF and Dialing Parameters
The 'DTMF & Dialing' page is used to configure parameters associated with dual-tone multi-
frequency (DTMF) and dialing. For a description of the parameters appearing on this page,
refer to ''Configuration Parameters Reference''

To configure the DTMF and dialing parameters:
1. Open the 'DTMF & Dialing' page (Configuration tab > Protocol Configuration menu
> Protocol Definition submenu > DTMF & Dialing
2. Configure the parameters as required.
3. Click the Submit
4. To save the changes to flash memory, refer to ''
3.3.5.5

Application Network Setting

The Application Network Setting
domains and interfaces. This submenu contains the following page items:

SRD Table (refer to ''

SIP Interface Table (refer to ''Configuring the SIP Interface Table''
3.3.5.5.1 Configuring the Signaling Routing Domain Table
The 'SRD Table' page allows you to configure up to five signaling routing domains (SRD).
An SRD is a set of definitions of IP interfaces, device resources, SIP behaviors and other
definitions that together create (from the IP user's perspective) from one physical device,
multiple virtual multi-service gateways.
SRD provides the following:

Multiple, different SIP signaling (SRD associated with a SIP Interface) and RTP media
SIP User's Manual
Figure 3-70: DTMF & Dialing Page
button to save your changes.
submenu allows you to configure SIP signaling routing
Configuring the Signaling Routing Domain Table''
110
Mediant 600 & Mediant 1000
on page 247 .
page item).
Saving Configuration''
Document #: LTRT-83306
on page 199 .
on page 110 )
on page 112 )