SIP User's Manual
To configure the Trunk Group Table:
1.
Open the 'Trunk Group Table' page (Configuration tab > Protocol Configuration
menu > Trunk Group submenu > Trunk Group
2.
Configure the Trunk Group according to the table below
3.
Click the
4.
To save the changes to the flash memory, refer to ''
199
.
Parameter
Module
[TrunkGroup_Module]
From Trunk
[TrunkGroup_FirstTrunkId]
To Trunk
[TrunkGroup_LastTrunkId]
Channels
[TrunkGroup_FirstBChannel],
[TrunkGroup_LastBChannel]
Version 6.0
Figure 3-67: Trunk Group Table Page
Submit
button to save your changes.
Table 3-16: Trunk Group Table Parameters
The module type for which you want to define the Trunk
Group.
Starting physical Trunk number in the Trunk Group. The
number of listed Trunks depends on the device's hardware
configuration.
Note: This parameter is applicable only to PRI and BRI
modules.
Ending physical Trunk number in the Trunk Group. The
number of listed Trunks depends on the device's hardware
configuration.
Note: This parameter is applicable only to PRI and BRI
modules.
The device's
channels (digital module). To enable channels, enter the
channel numbers. You can enter a range of channels by using
the format [n-m], where n represents the lower channel
number and m the higher channel number. For example, [1-4]
specifies channels 1 through 4.
Notes:
The number of defined channels must not exceed the
maximum number of the Trunk's B-channels.
To represent all the Trunk's B-channels, enter a single
asterisk (*).
page item).
.
Saving Configuration''
Description
channels/ports (analog module) or Trunk B-
103
3. Web-Based Management
on page
March 2010