Configuring The Multiple Interface Table - AudioCodes Mediant 1000 User Manual

SIP User's Manual

IP Routing Table (refer to ''Configuring the IP Routing Table''

QoS Settings (refer to ''Configuring the QoS Settings''
3.3.1.1

Configuring the Multiple Interface Table

The 'Multiple Interface Table' page allows you to configure up to 16 logical network
interfaces, each with its own IP address, unique VLAN ID (if enabled), interface name, and
application type permitted on the interface:

Control

Media

Operations, Administration, Maintenance and Provisioning (OAMP)
This page also provides VLAN-related parameters for enabling VLANs and for defining the
'Native' VLAN ID (VLAN ID to which incoming, untagged packets are assigned). For
assigning VLAN priorities and Differentiated Services (DiffServ) for the supported Class of
Service (CoS), refer to ''
Notes:
Version 6.0
Configuring the QoS Settings''
•
Only eight media (RTP) IP address interfaces can be implemented in call
routing. These interfaces are assigned to Media Realms in the 'SIP
Media Realm' table (refer to "Configuring Media Realms" on page 99).
•
Once you access the 'Multiple Interface Table' page, the 'IP Settings'
page is no longer available.
•
For a detailed description with examples for configuring multiple network
interfaces, refer to "Network Configuration" on page 610).
•
You can view all configured IP interfaces that are currently active in the
'IP Active Interfaces' page (refer to ''
page 211 ).
•
When adding more than one interface to the table, ensure that you
enable VLANs using the 'VLAN Mode' (VlANMode) parameter.
•
When booting using BootP/DHCP protocols (refer to the Product
Reference Manual), an IP address is obtained from the server. This
address is used as the OAMP address for this session, overriding the IP
address you configured in the 'Multiple Interface Table' page. The
address specified in this table takes effect only after you save the
configuration to the device's flash memory. This enables the device to
use a temporary IP address for initial management and configuration,
while retaining the address (defined in this table) for deployment.
•
For an explanation on configuring tables in the Web interface, refer to
'' Working with Tables''
•
You can also configure this table using the ini file table parameter
InterfaceTable (refer to ''Networking Parameters''
on page
on page
Viewing Active IP Interfaces''
on page 39 .
61
3. Web-Based Management
on page 68 )
70 )
70 .
on
on page 247 ).
March 2010