Figure 3-100: Automatic Dialing - AudioCodes Mediant 1000 User Manual

SIP User's Manual

To configure Automatic Dialing:
1. Open the 'Automatic Dialing' page (Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Automatic Dialing
2. In the 'Destination Phone Number' field corresponding to a port, enter the telephone
number that you want automatically dialed.
3. From the 'Auto Dial Status' drop-down list, select one of the following:
•
Enable [1]: The number in the 'Destination Phone Number' field is automatically
dialed if the phone is off-hooked (for FXS interfaces) or a ring signal (from
PBX/PSTN switch) is detected (FXO interfaces). The FXO line is seized only after
the SIP call is answered.
•
Disable [0]: The automatic dialing feature for the specific port is disabled (i.e., the
number in the 'Destination Phone Number' field is ignored).
•
Hotline [2]:
♦
♦
4. Click the
5. To save the changes to flash memory, refer to ''
Version 6.0
Figure 3-100: Automatic Dialing Page
FXS interfaces: When a phone is off-hooked and no digit is dialed for a
user-defined time (configured using the parameter HotLineToneDuration),
the number in the 'Destination Phone Number' field is automatically dialed.
FXO interfaces: If a ring signal is detected, the device seizes the FXO line,
plays a dial tone, and then waits for DTMF digits. If no digits are detected for
a user-defined time (configured using the parameter HotLineToneDuration),
the number in the 'Destination Phone Number' field is automatically dialed by
sending a SIP INVITE message with this number.
Submit button to save your changes.
Saving Configuration''
173
3. Web-Based Management
page item).
on page 199
March 2010
.